We Are Open: A Message About COVID-19

Priority Rental
Call Now: 1-800-810-4181
  • Portable A/C
    • Portable AC Rental
    • Spot Cooler Rental
    • Temporary Air Conditioning
    • Event Air Conditioning
    • Air Conditioning Rental
    • Outdoor Cooling
    • Evaporation Cooling/Swamp Coolers
  • Temp Heat
    • Indirect Fired Heaters
    • Direct Fired Heaters
    • Electric Heaters
    • Construction Heaters
    • Temporary Heating Solutions
    • Tent Heaters
  • Air Quality Control
    • Air Scrubbers
    • Dehumidifiers
    • Industrial Fan Rentals
    • Water Restoration & Drying Equipment
    • Other Rentals
  • Videos
  • About
    • Climate Control Experts
    • Service Area
    • Meet Our Team
    • Reviews
  • Blog
  • Contact
Search the site...

Common Portable AC Error Codes

spot cooler HSC-60When you rent an air conditioner, it is important to understand some common warning indicators.  Most AC problems occur because of issues with air flow or power requirements.

If your spot cooler has an error code listed, refer to the list of codes below to determine what the problem is. If you are having a problem with your unit, please call us immediately at 800-810-4181. Always remember that if you are restarting the unit, for any reason, be sure to place the unit back on “cool” mode.

Spot Cooler Errors & Warning Indicators

  • “E1” – High Pressure: The pressure of the compressor is too high and the high pressure switch is open.  The ‘Error’ LED will be on.
    • Solution: Ensure exhaust duct is not blocked/kinked. Do not use the air conditioner if ambient temperature is higher than 113° F.
  • “E2” – Low Pressure: The pressure of the compressor is too low.   The ‘Error’ LED will be on.
    • Solution: Clean filters & coils. Verify Power. Check filters evaporator/condenser. Check evaporator/condenser coils. Check refrigerant level and/or refrigerant leak.
  • “E3” – Sensor Problem: The temperature sensor is short circuited or cut.  The ‘Error’ LED will be on.
    • Solution: Exchange temperature sensor.
  • “E4” – Compressor Problem: Occurs when the over current from the compressor is detected.
    • Solution: Verify Power (Voltage/Amps). Check flex for restrictions.
  • “E5” – Fan Motor Problem: Occurs when the over current from the fan motor is detected.
    • Solution: Verify Power (Voltage/Amps). Check flex for restrictions.
  • “E6” – Blower Motor Problem: Occurs when the over current from the blower motor is detected.
    • Solution: Verify Power (Voltage/Amps). Check flex for restrictions.
  • “FU” – Condensation Water Tank Full: FU will be displayed on our units and the “Water Full” LED light will be on. *Tank should be emptied on a daily basis*
    • Solution: Empty the water tank.
  • “AF” – Anti-freezing: The temperature of the evaporator is below 28° F.  “AF” is displayed and the ‘Error’ LED is on.
    • Solution: Do not use the unit in an ambient temperature less than 72° F. Check refrigerant level.
  • “AL”– Fire Alarm Signal: Reset the unit by pushing and holding the “OFF TIMER” button for 5 seconds.
    • Solution: Reset the unit by pushing and holding the “OFF TIMER” button for 5 seconds.
  • “TP”– Tank Position: If the water tank is not in position correctly, the LED “Align Drain Tank” light will be on.
    • Solution: Place the water tank in the right position.

For a full list of spec sheets on our AC units, visit our portable AC store page.

 

Comments are closed.

Popular Posts

  • What is the Difference Between Direct and Indirect Fired Heaters?
  • How Much Does it Cost to Rent a Dehumidifier?
  • What is a TON of Air Conditioning?
  • What Do I Need to Know Before Renting Temporary AC?
  • Heating Strategies for Warehouses

Categories

  • AC Resources (Spanish) (6)
  • Air Conditioning Information (66)
    • AC Resources (15)
    • AC Troubleshooting (15)
  • Air Filter Information (16)
    • Air Filter Resources (15)
  • Dehumidifier Information (18)
    • Dehumidifier Resources (11)
  • FAQ's (6)
  • News (88)
  • Swamp Cooler Resources (2)
  • Temporary Heating Information (50)
    • Heater Troubleshooting (13)
    • Heating Resources (18)

Main Office

3033 Market Street
Aston, PA 19014

  • 484-482-2040

NJ Location

1 West Baltimore Ave,
Linden, NJ 07036

  • 347-269-4480

MD Location

6675 Amberton Dr., Ste 11
Elkridge, MD 21075

  • 410-793-7966

Contact Us

  • 1-800-810-4181
  • sales@priorityrental.com
  • Contact Us
  • View Service Area
    • Facebook
    • Linkedin
    • Twitter
    • YouTube
© Priority Rental • Site by Boom Visibility
  • Master Terms
  • Privacy Policy
  • Sitemap